There was a misprint on batches VSLN & VSKS of 10 ML Vapour 2 E-Liquid. The correct expiration date is July 2019.
With our Series 3 Ceramic E-Liquid cartridge, you can enjoy the superior flavor and vapor of a ceramic heater with your favorite high PG e-liquid. An incredible value, the Series 3 ceramic cartridge can be refilled up to 40 times – four times more than the original. This cartridge features a 1.2 ohm atomizer with a ceramic wick and stainless steel coil; it has an e-liquid storage capacity of 1.6 ml.
Upon first use, be sure to allow the cartridge to sit for at least 15 minutes after filling it. This will allow time for the wick to become fully saturated and deliver the best possible flavor. Look for the small “P” etched in the side of the cartridge to confirm that the cartridge is for PG (VG cartridges are marked with a small “V”), then unscrew the mouthpiece and fill the cartridge. After 15 minutes, drop the cartridge into the cartridge chamber of your Series 3 or Series 3X device and begin puffing.
|Cartridge Type||S3 PG Ceramic|
Refers to which device platform (or battery) the cartridge is compatible with.
|S3 / S3X|
|Pre-Filled / Re-Fillable
Some cartridges come prefilled with e-liquid for added convenience. Other cartridges, known as blanks, can be filled with the compatible e-liquid of your choice.
The useable storage capacity of the cartridge.
|Puffs per Fill
The average number of 2 second puffs a cartridge provides when filled to capacity.
|Fills per Cartridge
The number of times a cartridge may be refilled.
|Up to 40 Refills|
E-liquid compatibility with either PG or VG e-liquid. Some cartridges offer interchangeable atomizers, which may allow the cartridge to be used with both PG and VG e-liquids.
Average electrical resistance of the heater.
|1.1 - 1.3 Ω|
The material which transfers e-liquid to the heater.
|Ceramic Solid State|
The material the heater is made from.
|Stainless Steel Wire|
Also known as Vapor Saturation Rate. This measures vapor thickness on a scale of 1-100. If applicable, the device is tested at highest voltage setting and with lowest supported impedance.
|70 out of 100|